Pass Labs 1XA160.5 Uživatelský manuál

1XA160.5 Owner’s Manualpass®XA160.5 Owner’s ManualApril 25, 2007

10XA160.5 Owner’s ManualAfter that, the longevity will depend upon the number of operating thermal cycles, but we can say that we have had amplifiers

11XA160.5 Owner’s Manual

12XA160.5 Owner’s ManualWarranty InformationAll Pass Laboratories products purchased new from an authorized Pass Laboratories dealer in North America

13XA160.5 Owner’s ManualWater and moisture: Electrical devices should not be used near water ( as per example, near a bathtub, washbasin, kitchen sin

2XA160.5 Owner’s ManualNelson Pass has been designing audio electronics since about 1971, first with ESS (remember Heil transformers?), and then formi

3XA160.5 Owner’s ManualWe start with simple FET circuits already having low distortion and noise, and arrange them in two symmetrical halves. The two

4XA160.5 Owner’s ManualAll the usual performance metrics - power, distortion, noise, input impedance, damping factor and bandwidth have all been impro

5XA160.5 Owner’s ManualSET UPX amplifiers run at about the same power as their output rating, and XA amplifier run more than twice that. The heat sin

6XA160.5 Owner’s Manual The amplifier’s voltage and current rating are indicated on the rear panel. It will be either 240 volts, 230 volts, 220 volts

7XA160.5 Owner’s ManualSo the amplifier is sitting there unconnected.Make sure that the rear panel power switch/breaker is off (down). Plug the AC c

8XA160.5 Owner’s Manualpin 3 is inverted (negative) input. Pin numbers are marked on the XLR. If you re-install the jumper incorrectly or leave it

9XA160.5 Owner’s Manualthe temperature exceeds 75 degrees Centigrade. This thermal cutout should never occur in real life. This is a very rare occur